According to an article on Healthy Water from the CDC, they make a bold statement that “The CDC recommends not using cyanuric acid(CYA) or chlorine products with cyanuric acid in hot tubs/spas.”  The reason is the build-up of CYA causes consumers to potentially soak in water that is not properly sanitized because too much CYA in water inhibits the effectiveness of the chlorine.

The Pennsylvania Department of Health in December 2016 published this statement “At even moderate levels of cyanuric acid, the amount of time it takes chlorine to kill pseudomonas aeruginosa (the bacteria that causes “hot tub itch) can be as much as a hundred times as long as in a hot tub or spa without cyanuric acid.”

These studies are recognizing what has been known in the swimming pool world for some time – that too much CYA is a bad thing. The reason is it affects the kill rate of chlorine. The kill time (CT value) for pseudomonas aeruginosa (the organism associated with hot tub rash) with no CYA is about 20 seconds. It is 1 minute and 30 seconds with 50 ppm CYA, and nearly 2 minutes with 100 ppm CYA. As CYA increases, the effectiveness of the chlorine decreases.


To achieve the same kill time would require a much greater chlorine level in the water. But using Dichlor you keep increasing the CYA level so it’s harder and harder to maintain the right chlorine level.


See all the CYA facts! 

Did you know Dichlor is about 50% Cyanuric Acid?
Did you know CYA can build up in as little as 7 weeks?
Did you know FROG @ease has no CYA?
Learn more at NoCYA.com

LEARN MORE AT NOCYA.COM

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *